|DIY Auto Upholstery Restoration -|
Taking one look at the cracked and splitting car seat, we figured the upholstery was beyond repair. That probably meant an expensive re-covering job, which didn't seem likely, given the age and value of the vehicle. Not happy about the costly alternatives, we decided to give it a try ourselves. The results were well worth the effort, as this repair cost only $150 to $200, much less than a new leather upholstery job. Here’s how we succeeded in fixing the upholstery, and how you can do the same.
First, do your best to clean up the old upholstery. On leather seats, usually the flat panels on the bottom and back are made of genuine animal hides, and the sides are color-matched vinyl, because of its better flexibility. We discovered that some of the apparent dirt in the grain was actually cracked and damaged leather, which would require a re-dye or color coat (which we might attempt at a later date).
Prior to proceeding with repairs, a thorough cleaning is necessary to remove other types of chemicals that might have been applied to the surface. Because water and oil don't mix, silicone-based or petroleum treatments are the enemy.
Once the material is thoroughly cleaned and scrubbed, the first stage of the repair involves applying thin layers of a repair compound with a palette knife between the torn edges of the vinyl, directly onto the white backing material. The edges are not actually joined together, as in stitching together a torn piece of fabric. Instead the repair acts as a filler/patch. After a brief warming from a heat gun to cure the patch, apply a piece of flexible material with a grain imprint that imparts a matching texture to the smooth surface of the patch.
Once that dries, clean the surface yet again, and apply a vinyl-prepping compound to ensure the color will adhere properly. To verify that, do a "tape test" (using a piece of masking tape) to make sure the surface is sufficiently tacky and will accept the dye.
Spraying on the color topcoat proved to be the trickiest part, since beige upholstery is usually the hardest to match. Experiment with a few different combinations of tints from bottles of dye to try and get the exact hue. It helps to blend the colors together.
So this type of repair, which can be done on a variety of soft and hard plastics, along with leather upholstery, is more than just a stitch in time. With a bit of color sense and artistry, your repair can look as good as new.
Inspecting the Damage – The vinyl on the sides of the leather upholstery isn't just worn, but split in places. It looks too damaged to repair, as the stitched seam is cracked as well. The dark lines in the leather won't come clean, because the leather is actually damaged. Spraying on a color coat is the only option here.
|Before Repair – Any previously applied treatments, especially silicone-based, must be cleaned off thoroughly with a scrubbing pad and a foaming solution.|
|Begin Patching – After masking off the area to be repaired with tape, the patching material is applied in several thin layers with a palette knife to the exposed white backing material.|