Mobil 1 Logo with trademark
Mobil 1 RacingTM
Car Care for a Better Ride

My Mobil
Discover the Benefits of Membership
Forgot your username or password?

Newsfeedsfacebook
YouTubeMobil 1 Merchandise
Mobil 1 Rewards
Do-It-Yourself Projects
Align It Yourself
By Tom Morr/autoMedia.com
Printable version
Degree of DifficultyDifficult
Difficult
Estimated Time240 minutes
240 minutes
Keeping Your Toe-in Out of a Jam -
 
Most people think that wheel alignment is best left to the professionals. This is true in many respects, but some alignment specs are easy to check yourself, and toe is one aspect of alignment that can be checked at home. This can come in handy after replacing steering or suspension components so that the vehicle won't be wildly out of adjustment for the trip to the alignment shop, or at the very least provide a better understanding of the alignment process.
Align it Yourself
Theory
In theory, all four wheels should be perpendicular to the ground and parallel to each other. When the vehicle starts pulling to one side—or after a sharp impact with a curb—most drivers suspect that the wheels might be out of alignment. Irregular tire wear, vibration, and odd handling characteristics are other clues.
 
The three factors that affect alignment are toe-in, camber and caster. The first two can easily be checked at home.
 
Toe-in
Cars' front tires are slightly pigeon-toed to intentionally place a very slight load on the wheel bearings. Typical toe-in specs vary from 1/32 to 1/8-inch, depending on the vehicle. Check a service manual for your car's acceptable range.
 
The best tip-off to a toe problem is a saw-tooth wear pattern that's equal on both front tires. If the tread blocks point toward the frame, then toe-in is excessive; pointing outward indicates too much toe-out.
 
Toe-in spec-check and adjustment are shown in the accompanying photos. Although no specialized tools are necessary to check toe, companies such as Eastwood, JC Whitney and Harbor Freight sell tools specifically for this purpose.
 
Two things to remember when measuring and adjusting toe: First, true spec is measured midway up the tires. If the car's body makes this impractical, take the front and rear measurements 1/4 of the way up the tires, then double that to get the true toe as it would be in the center of the tires. Also, an off-center steering wheel can sometimes be corrected by adjusting one tie-rod more than the other. (Steering wheel position has no affect on your final alignment.)
 
Camber
Camber is the measurement of tire lean in degrees. If the top of the tire tilts inward, the vehicle has negative camber; outward lean is positive camber. Most newer vehicles have slightly negative camber to improve stability and handling.
 
Two indicators of camber problems are the vehicle pulling to one side (the one with more positive camber or possibly less air in the tire) and uneven tire wear across the tread. Camber is easy to check with an angle finder and a straight edge, ideally one that's the same length as the wheel diameter so that tire sidewall bulge doesn't interfere with the straight edge.
 
Many front-wheel-drive cars don't have camber adjustments, and out-of-spec camber here often indicates bent or worn parts. On vehicles that have adjustable camber, the job can involve adding shims between the control arms and frame and turning cam bolts. Many people prefer to let an alignment shop make these adjustments, particularly if their car has independent rear suspension.
Return to list of articlesPrintable version
Page:  1 | 2 | 3 | 4
Copyright 2005-2014 Exxon Mobil Corporation. All Rights Reserved. ExxonMobil Home | Site Map | Contact Us | Privacy | Legal